In addition to the system accuracy, the mounting and adjustment of the scanning head normally have a significant effect on the accuracy that can be achieved with rotary encoders without integral bearings. Of particular importance are the mounting eccentricity and radial runout of the measured shaft.
The ECI/EQI 1300 inductive rotary encoders with EnDat01 are mechanically compatible with the ExN 1300 photoelectric encoders. The taper shaft (a bottomed hollow shaft is available as an alternative) is fastened with a central screw. The stator of the encoder is clamped by an axially tightened bolt in the location hole.
HEIDENHAIN is supplementing its existing program of inductive position encoders with its rotary encoder series ECI 4000/EBI 4000. The variants are modular devices without integral bearing and with a 90 mm hollow shaft. They enable you to replace the conventional toothed-belt drive for coupling a motor feedback system to torque motors.
The ERO modular rotary encoders consist of a graduated disk with hub and a scanning unit. They are particularly well suited for applications with limited installation spacet, or for applications where friction of any type must be avoided.
Encoders for Servo Drives
ECI 4010 / EBI 4010 – Absolute Rotary Encoders with 90 mm Hollow shaft for Safety-Related Applications
ECI 4090S – Absolute Rotary Encoder with 90 mm Hollow Shaft and DRIVE-CLiQ Interface for Safety-Related Applications
ECI 4090 S - Absolute Rotary Encoder with 180 mm Hollow Shaft and DRIVE-CLiQ Interface for Safety-Related Applications
ECI 4010 / EBI 4010 - Absolute Rotary Encoders with 180 mm Hollow shaft for Safety-Related Applications
เวปไซต์นี้ใช้คุกกี้ โปรดยอมรับการใช้คุกกี้ เพื่อให้แน่ใจว่าหน้าเว็บแสดงการใช้ฟังก์ชันที่เหมาะสม